LP Controller Module - Universal

The Controller Module Harness for the LP-Series by Baja Designs is a purpose-built wiring solution designed to connect your LP4, LP6, or LP9 auxiliary light directly to a pre-wired switch panel or control module without any pinning, crimping, or guesswork involved. If you've already invested in a Switch-Pros, sPOD, or OE upfitter switch setup in your truck or Jeep, this harness is the clean, reliable link that completes the circuit.

The seven-foot length gives you enough reach to route the wiring neatly through your engine bay or cab, and the high-quality sheathing protects against abrasion, heat, and the general punishment that comes with serious off-road use. A clean install isn't just about aesthetics — properly protected and routed wiring means fewer points of failure on the trail when conditions get rough.

Keep in mind that each harness supports a single LP-Series light, so if you're running a pair of lights, you'll need two. For truck and Jeep owners who want a professional-grade result without spending hours sorting through connectors and wiring diagrams, this harness makes the job straightforward and the finished product look factory-clean.