Multicolor DRL LED Boards for the 2019–2021 Dodge Charger are a direct replacement for the factory LED panels inside the headlight, giving you full RGBW color control while keeping a clean OEM appearance. Because this install requires opening the headlights, professional installation is strongly recommended.
Watch the full install video below, or scroll down for the step-by-step written guide.
Table of Contents
- Installation Video
- Tools Required
- Installation Instructions
- Questions About the Install?
- Shop Dodge Charger Lighting at Ess K Customs
Installation Video
Tools Required
- Torx T15 screwdriver
- Torx T20 screwdriver
- Basic hand tools for headlight removal
Time Required: Approximately 3–4 hours.
Important: Headlights must be opened before proceeding with installation. Professional installation is strongly recommended.
Installation Instructions
Step 1 — Remove the four T20 Torx screws securing the black bezel inside the headlight. Carefully remove the bezel and set it aside.
Step 2 — Remove the two T20 Torx screws holding the heatsink and black alignment bracket in place. Unclip the power connector from the factory LED board. Remove the two T15 screws securing the alignment bracket to the heatsink, then remove the final T20 screw holding the factory board in place.
Step 3 — Carefully remove the thermal adhesion pad (sil-pad) from the back of the factory LED board and reattach it to the back of the new LED board.
Step 4 — Using the alignment tabs, place the new LED board into position and secure it with the original T20 screw. Reinstall the black alignment bracket using the original T15 screws — don't overtighten. Reinstall the heatsink using the original T20 screws.
Step 5 — Route the wiring out of the headlamp through the dust cap, sealing any holes you create. Reinstall the black bezel using the original T20 screws and reinstall the headlamp lens. Repeat Steps 1–5 for the opposite headlight.
Step 6 — Connect each LED board to its RGBW driver, then connect the drivers to a Diode Dynamics LED controller (sold separately). Do not connect the LED boards directly to the controller without the drivers.
Step 7 — Connect your controller to 12V power and ground, or to the included SolidState Relay Harness if applicable. Tap the appropriate factory wires to determine when the DRLs activate, such as parking lights or DRL signals.
Step 8 — Mount the drivers and controller outside of the headlight housing for serviceability, in a location away from the engine block to avoid excessive heat. Test the system thoroughly, then reseal the headlights and reinstall them on the vehicle. The install is complete.
Questions About the Install?
If you run into any issues during the installation, contact Ess K Customs — as an authorized Diode Dynamics dealer, we're here to help.
Shop Dodge Charger Lighting at Ess K Customs
Looking to upgrade your Charger's lighting? As an authorized Diode Dynamics dealer, Ess K Customs carries genuine products with full manufacturer warranty.
Shop LED Sidemarkers for 2015-2023 Dodge Charger →
This install guide applies to Diode Dynamics SKU: DD2282