The 2019-2025 Toyota RAV4 Fog Light Kit upgrades your factory fog lights with significantly improved output for better visibility in rain, snow, and low-light driving. Here's how to get it installed on your RAV4.
Watch the full install video below, or scroll down for the step-by-step written guide.
Table of Contents
- Installation Video
- Tools Required
- Installation Instructions
- Questions About the Install?
- Shop RAV4 Fog Light Kits at Ess K Customs
Tools Required
- 10mm socket
- Plastic trim removal tool
Installation Video
Installation Instructions
Step 1 — Open the hood and use a 10mm socket to remove the fasteners securing the top edge of the front bumper cover.
Step 2 — From underneath the vehicle, remove the fasteners securing the lower edge of the bumper cover.
Step 3 — Remove the fasteners and clips securing the front wheel liners. Repeat on both sides.
Step 4 — Carefully pull outward on the bumper cover to release it from the fender flares. Remove the retaining clip on each side.
Step 5 — Reach behind the driver-side wheel liner and disconnect any electrical connectors attached to the bumper cover, including the factory fog light harness.
Step 6 — With all fasteners and connectors removed, pull the bumper cover straight forward and set it aside on a protected surface.
Step 7 — Using a trim tool, release the wiring harness clips attached to the back of the factory fog light bezels.
Step 8 — Release the retaining tabs and remove the factory fog light bezels from the bumper cover.
Step 9 — Install the provided fog light bezels into the bumper and secure them using the factory clips. Repeat on the opposite side.
Step 10 — Mount the fog light pods into the bezels using the included hardware, following the washer orientation shown below. Plug in the Fog Light Adapter Harness (4P DT to DJ70 Adapter). Tap the Backlight wire to the Sidemarker power wire as shown.
Step 11 — Reinstall the front bumper cover, reconnect all electrical connectors, and test the fog lights for proper operation.
Step 12 — Aim the fog lights as needed, then reinstall all remaining fasteners and clips in reverse order of removal. The install is complete.
Questions About the Install?
If you run into any issues, contact Ess K Customs — as an authorized Diode Dynamics dealer, we're here to help.
Shop RAV4 Fog Light Kits at Ess K Customs
Ready to upgrade your RAV4's fog lighting? As an authorized Diode Dynamics dealer, Ess K Customs carries genuine products with full manufacturer warranty.
Shop SS3 Toyota RAV4 Fog Light Kit →
This install guide applies to Diode Dynamics SKUs: DD8819, DD8820, DD8821, DD8822, DD8823, DD8824